So I added a temp probe to my kettle but I am not liking where I placed it. If I move it what can I do to seal up the hole? by effpizzle 7 Comments zerocoldx911 11 months ago A nut and a bolt Zeroshifta 11 months ago I like that thermo where’d you get it pmac109 11 months ago A cork. From a wine bottle. clunkclunk 11 months ago JB weld to plug it, then you can sand off any excess and add a quick bit of paint if you want to protect any bare metal. mycophilz 11 months ago Why don’t you like the placement? N_thanAU 11 months ago Temp probes on lids are mostly useless anyway. I would just leave it there and grab a probe that will clip the grill. thenewTeamDINGUS 11 months ago Honda Bond and JB Weld.Wait which sub am I in again?Write A CommentYou must be logged in to post a comment.
clunkclunk 11 months ago JB weld to plug it, then you can sand off any excess and add a quick bit of paint if you want to protect any bare metal.
N_thanAU 11 months ago Temp probes on lids are mostly useless anyway. I would just leave it there and grab a probe that will clip the grill.
7 Comments
A nut and a bolt
I like that thermo where’d you get it
A cork. From a wine bottle.
JB weld to plug it, then you can sand off any excess and add a quick bit of paint if you want to protect any bare metal.
Why don’t you like the placement?
Temp probes on lids are mostly useless anyway. I would just leave it there and grab a probe that will clip the grill.
Honda Bond and JB Weld.
Wait which sub am I in again?