Anyone knows how to change the control wiring comnection. I am getting an Ignitor error so when I checked it, I discovered that the control wiring connection is melted, any ideas how to fix that?
by Life_Fix_6385
1 Comment
gormami
I had a Trager do a similar thing, but it was the connection at the control board that burned. I contacted their customer support and they sent me a new control board. You can replace the wires, but it is likely there is a short somewhere other than right there, so you should be very careful, and most likely, replace the board, unless you can find the short in the connector or immediately adjacent to it, like melted insulation that has allowed the conductors to touch.
1 Comment
I had a Trager do a similar thing, but it was the connection at the control board that burned. I contacted their customer support and they sent me a new control board. You can replace the wires, but it is likely there is a short somewhere other than right there, so you should be very careful, and most likely, replace the board, unless you can find the short in the connector or immediately adjacent to it, like melted insulation that has allowed the conductors to touch.