Egg Island completed. The frame is 1 1/2 18 gauge square tube welded. The drawers were simple 3/4" sliding on ply wood runners. The top and egg stand platform are edge glued cedar boards. The drawer fronts and siding were cut from 2 4X6 exterior panels I picked up at Menards. I attached them to the frame with Riv-Nuts. Easily disassembled if needed. The paint was matched at Ace, who also sells eggs. Drawer pulls are wrought iron found online. The wife thought it needed a new egg handle and chose this. I did the main design with Sketchup. I'm still learning to use that, but it worked out pretty well.
by Loud-Drawing1454
4 Comments
Mind doing one for me too? 🤪
Looks great! If i may, you will still need a heat shield (paving stone?) Under the stand.
The heat from the bottom will be too much for wood to handle and will slowly dry out and turn into a fire hazard.
Ive seen many posts on the Born To Egg FB group of people’s tables and decks start on fire because of this.
Have you used the weiner measuring tool yet?
You need a ceramic tile underneath the egg. You will burn the base board